ASSEMBLING THE PRESSURE WASHER
1. Slide the gun holder into position and snap it in place (Fig. 1).
2. Slide the gun stock in place and tighten it with the 4.8 mm x 12 mm screw using
a Phillips screwdriver (Fig. 2).
3. Install the water inlet adapter to the water inlet by rotating the silver inner collar
clockwise until it is securely tightened (Fig. 3).
4. Fit the spray lance into the trigger gun and rotate it until the two parts are se-
curely connected (Fig. 4).
5. Attach the high pressure hose coupler to the hose connector on the trigger
gun by pressing the coupling stogether and rotating the sleeve until the two are
securely mated (Fig. 5).
CONNECTING WATER SUPPLY HOSE TO THE PRESSURE WASH-
ER
1. Inspect the inlet screen on the water inlet adapter and remove any debris.
2. Turn on the water, allowing it to run through the hose for a few seconds to flush
out any debris.
WARNING:
The intake water temperature must not exceed 104°F
(40°C). The water supply must not exceed 101 PSI (700 kPa).
CAUTION:
Only use clean water for the pressure washer. Use of unfiltered
water containing corrosive chemicals will damage the unit.
3. Turn off the water. Connect the water supply hose to the orange part of the
water inlet adapter and tighten by hand.
NOTE: There must be a minimum of 10 feet of unrestricted hose between pres-
sure washer and the water faucet or shut off valve.
ASSEMBLY
WARNING:
Do not attempt to assemble or operate this pressure washer until you have read and understood this
entire manual. If you have any problems assembling or operating this unit, please call (800) 232-1195 M-F 8-5 CST
for customer service or email us at [email protected].
7
PACKING LIST
• Pressure Washer Body
• Trigger Gun
• Spray Lance
• Gun Holder
• Gun Stock
• Screw 4.8 mm x 12 mm
• Water Inlet Connector
• Nozzles (0°, 15°, 25°, 40° and soap nozzle)
• Nozzle Cleaner
• Operator’s Manual
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Spray Lance