ASSEMBLY INSTRUCTIONS
ASSEMBLY
Refer to the packing list on the back of this page to
gather the proper parts and tools for installing the
legs, wheels, and handles.
NOTE:
There are different
sizes of bolts/nuts, be sure to use the proper bolts/
nuts for each assembly step.
INSTALLING THE LEGS (FIG. 1)
The legs are installed on the side of the generator with
the engine and air filter.
1. Prepare a set of blocks on level ground (a 4×4
block of wood works well). Place the generator on the
blocks. Have someone help you lift the generator.
2. Slide one leg into place on the generator frame and
align the holes on the leg with the holes on the frame.
3. Slide the M6 bolts through the legs and generator
frame. Tighten the nuts onto the bolts using a wrench
(not included).
4. Repeat on the opposite side.
INSTALLING THE WHEELS
1. Insert the axle through the wheel, washer and gen-
erator frame (in that order). See Fig. 2.
2. Slide the cotter pin through the opening in the axle
to lock it into place. See Fig. 3.
3. Repeat on the opposite side.
INSTALLING THE HANDLE (FIG. 4)
1. Install the handle bracket on the top of the generator
frame. Secure it with two M8x35 bolts and two nuts.
2. Use the 8/M6x40 bolt and nut to secure the handle
to the handle bracket.
3. Install the handle stopper on the rectangular part of
the generator frame. Use the M6x55 bolt and a nut to
secure it into place.
NOTE:
Refer to your generator's instruction manual
before using the generator.
Fig. 1
Fig. 3
Fig. 2
HAVE PRODUCT QUESTIONS? NEED TECHNICAL
SUPPORT? Please feel free to contact us:
1-800-232-1195 (M-F 8AM-5PM CST)
Fig. 4
