BATTERY
ON
OFF
STARTING YOUR GENERATOR
BEFORE STARTING THE GENERATOR
1. Verify that the generator is outside on a dry, level surface with at least two feet of clearance on all sides.
2. To maximize safety, check that the generator is properly grounded (see “Ground the Generator”).
3. Check that there is a sufficient level of oil in the crankcase. Add oil if necessary (see “Add/check Oil”).
4. If using gasoline, make sure there is enough gasoline in the fuel tank. Add fuel if necessary (see "Add/check Fuel").
If using LPG, make sure there is enough propane in the tank, and that the tank and regulator hose are connected.
5. Make sure all electrical devices are unplugged from the generator during ignition. Otherwise it will be difficult for
the engine to start.
STARTING THE GENERATOR (GASOLINE)
1. Turn the ECO-MODE switch (Fig. 16) to "OFF" during starting.
2. Turn the BATTERY switch (Fig. 16) to "ON".
NOTE:
The battery switch must be turned ON when starting the
generator, regardless of the method or fuel source used.
3. Turn the 2-in-1 (Fig. 17) switch to the "RUN" position.
NOTE:
If you have repeated failed attempts to start the engine,
please consult the troubleshooting guide. If problems persist,
please call please call
1-(800) 232-1195
M-F 8-5 CST.
6. Allow the generator to run for several minutes before attempt-
ing to connect any electrical devices. This allows the generator to
stabilize its speed and temperature.
Option A: Electric Start
3. Press the engine start / stop button (Fig. A) for one second.
NOTE:
The engine start / stop button will begin flashing green,
and will automatically adjust the choke and start the engine.
NOTE:
The generator will make 6 attempts to start the engine.
If after 6 attempts the engine has not started, the engine start
/ stop button will flash red for 30 seconds. Check the trouble-
shooting steps. If after checking all these steps the engine still
will not start, contact WEN customer service for assistance.
Option B: Pull Start
3. Pull the recoil starter handle slowly until a slight resistance
is felt, then pull quickly to start the engine. Return cord gently
into the recoil starter. Never allow the cord to snap back (Fig.
18).
NOTE:
If the engine does not start after multiple attempts,
please consult the troubleshooting guide before attempting to
start the generator again. If problems persist, please contact
WEN customer service.
ON
OFF
ECO-MODE
Fig. 16
21
Fig. 18
Fig. A
Fig. 17