![background image](http://html.mh-extra.com/html/wen/ba1411/ba1411_instruction-manual_956569013.webp)
ASSEMBLY & ADJUSTMENTS
MOUNTING THE BANDSAW TO THE STAND
1. Locate the four mounting holes on the top of the stand. With the
help of a friend, or trustworthy foe, carefully lift the bandsaw onto the
stand and align the four holes with the four mounting bracket holes
(Fig. 4 - 1) on the saw.
2. Place an 8mm lock washer (Fig. 4 - 2) and an 8mm flat washer (Fig.
4 - 3) onto the threaded end of a M8x35 hex bolt (Fig. 4 - 4) before fit-
ting it through the mounting bracket and stand mounting hole. Secure
the hex bolt with a flat washer and an M8 hex nut (Fig. 4 - 5) as shown
in Fig. 4. Do not tighten mounting fasteners fully yet.
3. Repeat step 2 for the remaining three mounting holes.
4. Align the band saw so it is square to the base, then tighten all
mounting fasteners.
ASSEMBLING THE BANDSAW TABLE
NOTE:
The table comes with a protective coating to prevent rust. To
remove this coating, while wearing gloves, wipe off the coating with a
rag, then apply a small amount of acetone (nail polish remover) to a
shop towel and clean the table. Apply a coat of good-quality paste wax
to the table to protect it from rust.
1. Position the table trunnion (Fig. 5 - 1) onto the bandsaw as shown
in Fig. 5. Secure the trunnion to the bandsaw using two M8x30 hex
bolts and two 8mm lock washers (Fig. 5 - 2).
2. Place an M8 hex nut onto the threaded end of the M8x80 positive
stop hex bolt (Fig. 5 - 3). Thread the bolt into the trunnion, leaving
about two inches visible above the trunnion, as shown in Fig. 5. Once
the table is installed, it will rest level on the positive stop hex bolt.
3. Remove the table insert (Fig. 6 - 1) and the table pin (Fig. 6 - 2).
4. Align the blade with the table slot (Fig. 6 - 3) and carefully slide it
into the center of the table. Turn the table 90
º
counterclockwise and
set it on the trunnions, so that the two mounting bolts protrude down-
ward through the trunnions.
5. Secure the table by installing the two table lock knobs (Fig. 7 - 1)
onto the two protruding trunnion bolts as shown in Fig. 7.
6. Replace the table insert and table pin. Make sure the table insert
sits flush with the table top.
1
2
4
3
5
Fig. 5
Fig. 4
Fig. 6
Fig. 7
1
2
2
3
1
2
3
1
13