ASSEMBLY & ADJUSTMENTS
ASSEMBLING THE FENCE
1. Install the front fence rail (Fig. 8 - 1) on the front side of the table
using two M6x20 hex bolts, two 6mm lock washers, and two 6mm
flat washers (Fig. 8 - 2).
NOTE:
There are two sets of threaded holes on the front of the table.
Install the bolts in the lower set of holes.
NOTE:
Do not fully tighten the hardware until the front fence rail is
completely installed. Position the rail evenly along the table before
fully tightening the hardware.
2. Install the rear fence rail (Fig. 9 - 1) on the rear side of the table
using two M6x16 cap screws (Fig. 9 - 2). Secure them using the in-
cluded hex wrench.
3. Place the M8 hex nut onto the threaded end of the fence lock handle
(Fig. 10 - 1). Attach the fence lock handle to the fence (Fig. 10 - 2) and
secure it by tightening the hex nut against the fence.
4. Make sure that the fence lock handle is in the UP (unlocked) posi-
tion. Position the fence between the blade and column as shown in
Fig. 11 and place it on the front fence rail. Push the lock handle DOWN
to the locked position to secure the fence to the rail.
5. Place the M6 hex nut onto the fence stand-off (Fig. 11 - 1) and
thread it into the underside of the fence so that it rests on the rear
fence rail (Fig. 11 - 2). Make sure that the fence is level all the way
across. Tighten the hex nut against the fence to secure the stand-off
in place.
NOTE:
The fence may not be perfectly flush against the table when it
is leveled. This is normal.
Fig. 10
Fig. 8
2
1
Fig. 9
2
2
1
Fig. 11
1
2
1
2
14