![background image](http://html.mh-extra.com/html/wen/apex-pro-3710/apex-pro-3710_operators-manual_956568014.webp)
14
Mounting to Plywood
(Figure 5)
An alternative method of securing your table saw is to fasten the saw base to a mounting board 24" x
24" minimum size to prevent saw from tipping while in use. Any good grade of plywood with a 3/4"
minimum thickness is recommended.
1.
Follow instructions for mounting to workbench,
substituting a plywood board 24" x 24" minimum size
and using 5/16" flat head machine screws, flat washers,
and hex nuts (not included). Screw length must be at
least 2-1/2" more than the thickness of the mounting
board. Insert screws up through mounting board and
through base holes. Place flat washers on stud and
secure with hex nuts.
NOTE:
For proper stability, holes must be counter sunk
on bottom side of plywood so screw heads are flush with
the bottom surface of the supporting board.
2.
Securely clamp board (2, Figure 5)
to workbench (3, Figure 5)
using two or more ―C‖ clamps (4,
Figure5, not include).
Supporting surface where saw is to be mounted should be examined carefully after mounting to insure
that no movement can occur during use. If any tipping or walking is noted, secure the workbench or
stand before operating the table saw.
Summary of Contents for APEX Pro 3710
Page 1: ...1 ...
Page 26: ...26 Exploded View ...