![background image](http://html.mh-extra.com/html/wen/apex-pro-3710/apex-pro-3710_operators-manual_956568013.webp)
13
Mounting Table Saw to Workbench
(Figure 3 & 4)
If table saw is to be used in a permanent location, it should be fastened securely to a firm supporting
surface such as a stand or workbench, using the four mounting holes, 1 (Figure 3)
two of which are
shown.
When mounting table saw to a workbench or plywood, holes should be drilled through the supporting
surface of the workbench or plywood and a opening MUST be made the same size as the opening in
the bottom of the saw using the dimensions illustrated (Figure 4), so the saw dust can drop through.
1.
Each of the four mounting holes should be bolted securely using 5/16" hex nuts (not included).
Screw lengths should be 2-1/2" longer than the thickness of the bench top.
2.
Locate and mark where the saw is to be mounted.
3.
Drill four (4) 3/8" diameter holes through workbench.
4.
Place table saw on workbench aligning holes in base with holes drilled in workbench.
5.
Insert four (4) 5/16" screws and tighten.
Summary of Contents for APEX Pro 3710
Page 1: ...1 ...
Page 26: ...26 Exploded View ...