![background image](http://html.mh-extra.com/html/wen/apex-pro-3710/apex-pro-3710_operators-manual_956568012.webp)
12
Assembly and Adjustments
WARNING!
Prior to performing any assembly procedures, make sure the 10" table saw is
disconnected from its electrical power source.
Assembling the Leg Stand
(Figure 1)
Warning:
The stamped rails may have sharp edges. Be careful in handling the rails to
prevent being cut.
NOTE:
Use the screws, washers, and lock nuts
supplied in the
hardware bag to attach the pieces of the leg stand together. Do
not tighten the hardware completely until the leg stand is
completely assembled.
1.
Attach the long top plates (10, Figure 1)
to the legs (14,
Figure 1).
2.
Attach the long support plates (12, Figure 1)
to the legs (14,
Figure 1).
3.
Place the front and rear short top plates (11, Figure 1)
over
the side top plates (10, Figure 1). And attach to the legs (14,
Figure 1).
4.
Attach the front and rear short support plates (13, Figure 1)
to the legs (14, Figure 1).
5.
Tap the four rubber feet (15, Figure 1)
onto the bottom of the legs (14, Figure 1).
Mounting the Table Saw to the Leg Stand
(Figure 2)
NOTE:
Mount the table saw to the leg stand using the
hardware supplied in the hardware bag.
1.
Place the table saw onto the assembled leg stand so that the
four (4) mounting holes (1, Figure 2)
in the base of the saw
are over the four (4) mounting holes in the front and rear
top plates (2, Figure 2).
2.
Secure the table saw to the leg stand using four (4) bolts (3,
Figure 2), washers (4, Figure 2), and lock nuts (5, Figure 2).
IMPORTANT!
When mounting the table saw to the leg stand,
DO NOT overtighten the mounting hardware.
Warning!
Before operating table saw, securely fasten table saw to stand and entire unit must
be placed on solid, level surface.
Warning!
Do not stand on table saw sand or use as ladder or scaffolding.
Warning!
Do not use table saw if stand tips, slides, or moves in any way.
Summary of Contents for APEX Pro 3710
Page 1: ...1 ...
Page 26: ...26 Exploded View ...