![background image](http://html.mh-extra.com/html/wen/71707/71707_manual_956564012.webp)
WARNING:
To prevent serious injury from accidental operation, make sure the power cord is discon-
nected from the power source and the tool is turned OFF before assembly or making any adjustments.
ASSEMBLY
INSTALLING THE BLADE GUARD (Figs. 6 & 7)
1. Slide the blade guard bracket (Fig. 6 - 1) into the lip under the table behind the cutting wheel. Align the two slots
of the blade guard bracket with the two flat head screws (Fig. 6 - 2). Position the blade guard bracket between the
tabletop and the locking plate.
2. Position the bracket so that it is parallel with the cutting wheel. Using a Phillips head screwdriver (not included),
tighten the two flat head screws to secure the blade guard bracket in place.
3. Slide the blade guard over the bracket, align the holes (Fig. 7 - 1) in the blade guard with the slot in the blade
guard bracket.
4. Insert the hex bolt (Fig. 7 - 2) through the blade guard and bracket, and thread the knob (Fig. 7 - 3) onto the bolt.
Set the blade guard to the desired height and tighten the knob.
NOTE:
Do not over-tighten the protective guard. The guard should rise and fall freely as the workpiece is pushed
towards the wheel during cutting operation. Ensure the protective guard cannot touch the cutting wheel.
NOTE:
Before each operation, check the blade guard height to make sure it sits slightly above the tile. Adjust the
height if necessary. This will provide the maximum protection.
0
1
▲
INSTALLING THE RIP GUIDE AND MITER GUIDE
1. Place the rip guide on the saw table.
2.
Use the rip guide scale, located on front and rear of the table, to set the rip guide to the desired width of
cut.
3.
Push the locking lever down to secure to the saw table.
4.
Align the male dovetail under the miter guide with the dovetail groove in the top of the rip guide.
5.
Push the miter guide onto the rip guide to the desired operating position
▲
FILLING/CHANGING THE WATER RESERVOIR
1.
Fill the water reservoir with clean tap water.
Do not try to fill the water upper than max fill line. T
he water will
overflow from the overflow drain.
2.
To change reservoir water:
Unplug the saw.
Remove the overflow drain and empty waste water into a bucket. Do not allow the water
to splash onto the ground or around the machine. Rinse the machine thoroughly.
Discard the waste water in
accordance with local regulations.
Firmly push the overflow drain into the hole in the bottom of the water fill
reservoir.
Replace
with clean water.
Fig. 6
Fig. 7
1
1
2
3
2
12
Summary of Contents for 71707
Page 22: ...EXPLODED VIEW PARTS LIST 22 ...
Page 24: ...THANKS FOR REMEMBERING ...