![background image](http://html.mh-extra.com/html/wen/71707/71707_manual_956564013.webp)
INSTALLING THE RIP GUIDE (Fig. 8)
1. Place the rip guide (Fig. 8 - 1) onto the saw table, with the locking lever (Fig. 8 - 2) in the unlocked (raised) posi-
tion.
2. Refer to the rip guide scale on the front and rear of the table and set the rip guide to the desired width of cut.
3. Push the locking lever (Fig. 8 - 2) down to secure the rip guide onto the saw table.
NOTE: If the rip guide is loose, tighten the 6mm nut on the end of the guide (71707-071), and try again. Make
adjustments to the nut as necessary.
INSTALLING THE MITER GUIDE (Fig. 9)
1. Slide the miter guide onto the rip guide.
2. The miter angle can be adjusted from 0° to 45°. Loosen the miter guide knob (Fig. 9 - 1) and rotate the guide to
the desired angle. Tighten the miter guide knob to lock the miter guide’s angle.
WARNING:
To prevent serious injury from accidental operation, make sure the power cord is discon-
nected from the power source and the tool is turned OFF before assembly or making any adjustments.
ASSEMBLY
0
1
▲
INSTALLING THE RIP GUIDE AND MITER GUIDE
1. Place the rip guide on the saw table.
2.
Use the rip guide scale, located on front and rear of the table, to set the rip guide to the desired width of
cut.
3.
Push the locking lever down to secure to the saw table.
4.
Align the male dovetail under the miter guide with the dovetail groove in the top of the rip guide.
5.
Push the miter guide onto the rip guide to the desired operating position
▲
FILLING/CHANGING THE WATER RESERVOIR
1.
Fill the water reservoir with clean tap water.
Do not try to fill the water upper than max fill line. T
he water will
overflow from the overflow drain.
2.
To change reservoir water:
Unplug the saw.
Remove the overflow drain and empty waste water into a bucket. Do not allow the water
to splash onto the ground or around the machine. Rinse the machine thoroughly.
Discard the waste water in
accordance with local regulations.
Firmly push the overflow drain into the hole in the bottom of the water fill
reservoir.
Replace
with clean water.
Fig. 8
Fig. 9
1
2
1
13
Summary of Contents for 71707
Page 22: ...EXPLODED VIEW PARTS LIST 22 ...
Page 24: ...THANKS FOR REMEMBERING ...