![background image](http://html.mh-extra.com/html/wen/3922/3922_instructional-manual_956544011.webp)
ASSEMBLY & ADJUSTMENTS
WARNING!
TO REDUCE RISK OF INJURY:
• When carrying the saw, hold it close to your body to avoid
injury to your back. Bend your knees when lifting the saw.
• Carry the saw by the base. Do not carry the saw by the
power cord or upper arm.
• Secure the saw in a position where people cannot stand,
sit, or walk behind it. Debris thrown from the saw could
injure people standing, sitting, or walking behind it. Secure
the saw on a firm, level surface where the saw cannot
rock. Make sure there is adequate room for handling and
properly supporting the workpiece.
BLADE GUARD FOOT ADJUSTMENT
When cutting at angles, the blade guard foot should be adjusted
so it is parallel to the table and rests flat above the workpiece.
1. To adjust, loosen the screw (Fig. 6 - 1), tilt the foot (Fig. 6 - 2)
so it is parallel to the table, and tighten the screw.
2. Loosen the height adjustment knob (Fig. 7 - 1) to raise or
lower the foot until it just rests on top of the workpiece. Tighten
the knob.
ADJUSTING THE DUST BLOWER
For best results, the dust blower tube (Fig. 8 - 1) should be ad-
justed to direct air at both the blade and the workpiece.
DUST COLLECTION PORT
A hose or vacuum accessory (not provided) should be connect-
ed to the dust chute (Fig. 9 - 1). If excessive sawdust buildup
occurs inside the base, use a wet/dry vacuum cleaner or manu-
ally remove sawdust by unlocking both side panel knobs and
opening the side panel open. Once the sawdust is removed,
close the side panel and re-lock both knobs to ensure safe and
efficient cutting
Fig. 6
2
1
Fig. 7
2
Fig. 8
1
Fig. 9
1
11