Welkin WKEM002, User Manual

Page: 5 / 22

5
Parts Assembly
Carefully place the bicycle on a flat ground so that it rests on the front fork and rear wheel.
Front Wheel
1. Remove the front fork protector from the front fork. (Please note: front fork protector is
used to prevent the fork from being deformed during transport. It belongs to the packing
material. You can throw away it!)
2. Take out the front wheel fixed axles, according to the picture installed in a good direction:
thick washer is on the right side of the thin washer is on the left (disc brake) direction; First
remove the left direction of the nut washer gasket, etc., put the shaft through the front wheel
hole, and then put the left direction of the nut washer gasket, etc., back on the shaft.
3. When the front wheel is mounted on the fork, pass the quick-release lever through the
center of the front axle, then adjust the nut locking, and then press the quick-release lever. Be
careful not to lose the fittings inside the quick removal lever.
Handlebars
1. Place the handlebars on the mounting place of the handlebars, and then tighten the 4
screws on the handlebars to the most comfortable position on the front, and adjust the front
wheel directions by adjust another 2 screws.