7.3.2 SHUTTER (Condition and Speed Control)
Auto or manual control can be selected.
When the SETUP menu is on the screen, please position the arrow to point to 'SHUTTER' by using the DOWN button.
Please select the shutter mode by pressing the LEFT or RIGHT button.
FLK:
Please select 'FLK' mode when flickering occurs on the screen, due to an imbalance between illumination
and frequency. NTSC Model:1/100, PAL MODEL: 1/120
ESC:
Auto control of the shutter speed can be achieved. When ESC mode is on, the speed is controlled
automatically according to the brightness of the screen.
MANUAL:
The shutter speed can be controlled manually.
Please select 'MANUAL' mode if you wish to adjust the shutter manually.
You can select speed from '1/60' to '1/120,000'sec (NTSC Models), '1/50' to '1/120,000'sec (PAL Models)
Please press the SETUP button when all the settings are complete.
Digital OSD Camera Installation Guide
16
SETUP
LENS
SHUTTER
WHITE BAL.
BACKLIGHT
MANUAL
ESC
ATW
OFF
SETUP
LENS
SHUTTER
WHITE BAL.
BACKLIGHT
MANUAL
ESC
ATW
OFF
7.3.3 WHITE BALANCE Control
The screen color can be adjusted by using the WHITE BALANCE function.
Please position the arrow to point to 'WHITE BAL' on the SETUP menu by using the UP and DOWN buttons.
Please select the mode you wish to operate by pressing the LEFT or RIGHT button.
Please select one of the 3 modes below.
ATW(Auto Tracking White Balance):
This mode can be used within the color temperature range 1,800 K ~ 10,500 K
(eg, fluorescent light, outdoor, sodium vapor lamp or inside tunnels)
AWC(Auto White Balance Control):
Please press the SETUP button while the camera is directed at a piece of white
paper to obtain the optimum state under current illumination. If the environment
including the light source is changed, you have to adjust the white balance again.
MANUAL:
The manual adjustment mode enables finer adjustment.
Please select ATW or AWC first.
Please change to manual adjustment mode and press the SETUP button.
Please set the appropriate color temperature,
and then increase or decrease the red and blue color values
while monitoring the color changes on the object.
Digital OSD Camera Installation Guide
17
Note
Under the following conditions the WHITE BALANCE function may not operate properly.
In such cases, please select the AWC mode.
When the object's surroundings have a very high color temperature (eg, a clear sky and sunset)
When the object's surroundings are dark
If the camera directly faces a fluorescent light or is installed in a place where there are considerable
changes in illumination, the WHITE BALANCE function may become unstable.