User manual
TAXI-CHECK – V1.3
- 18
-
5.0 Error Messages
The following error messages may be encountered when using the system.
5.1 Error 1
Handheld meter is attempting to find the roller bed unit.
If no unit is found within required time frame the meter will advance to
error 2
.
5.2 Error 2
Handheld meter has not received signal from the roller bed unit.
1. Check the power is switched on to the roller bed electronics.
2. Check that both the handheld meter and roller bed electronics are set to the
same rf channel.
5.3 Error 3
Handheld meter has lost signal from the roller bed unit during a full or quick
meter test.
The likely causes are power failure to the base unit or external rf interference.
The handheld meter will advance to
error 1
and start searching for the unit.
1. Try repeating the calibration procedure.
2. If the problem persists try increasing the rf power or change the rf channel.
5.4 Error 4
Handheld meter has lost signal from the roller bed unit during a calibration.
The likely causes are power failure to the base unit or external rf interference.
The handheld meter will advance to
error 1
and start searching for the unit.
1. Try repeating the calibration procedure.
2. If the problem persists try increasing the rf power or change the rf channel.
ERROR!
NO BASE UNIT FOUND
WITHIN VICINITY
DATA LINK LOST
TEST TERMINATED!
DATA LINK LOST
CALIBRATION
TERMINATED!
. . . SEARCHING . . .
