User manual
TAXI-CHECK – V1.3
- 19
-
5.5 Error 5
The data being received has too many data errors.
This can be caused by external rf interference.
1. If the problem persists, try increasing rf power or change the rf channel.
5.6 Error 6
During a test the maximum speed is 40km/h. If this limit is exceeded the following
message will appear. The user must slow down.
5.7 Error 7
If the user does not slow down during
Error 6
the following message will appear.
This is the last warning given to the user before the test will abort.
5.8 Error 8
The roller bed unit has failed to detect the calibration jig while in calibration mode.
1. Check the calibration jig is plugged in properly.
2. Check for possible cable breakage on the calibration jig.
5.9 Error 9
The roller bed unit has detected that the calibration jig is still plugged in.
INTOLERABLE
COMMUNICATION
ERRORS
PLEASE PLUG
CALIBRATION UNIT IN!
SLOW DOWN!
MAX SPEED 40km/h
SLOW DOWN!
FINAL WARNING!
PLEASE REMOVE
CALIBRATION UNIT!