Weishaupt WTC 45-A, Installation And Operating Instructions Manual, Page: 38 / 90

38
6
Limited
Code Process value display Unit
System
I10 Operating phase (see also
➩
table operating phases Ch. 6.3.2)
I11 Load setting [%]
I12 Damped external temperature of weather compensation B1 [°C]
I13 Heat demand FS/EM heat circuit [°C] or [%]
I14 SCOT
®
base value [Point]
I15 Temperature setpoint remote control operation 4…20 mA N1 [mA]
Actuators
I21 Start signal gas correcting element [%]
I22 Set speed PWM pump PWM pump [%]
I23 Fan speed [x10 RPM]
Sensors
I30 Flow temperature (safety temperature sensor) [°C]
I31 Flue gas temperature [°C]
I32 Ionisation signal (SCOT ® actual value) [Point]
I33 External temperature B1 B1 [°C]
I34 DHW temperature (versions -W/-C) B3/-C [°C]
I37 Throughput value (version -C) -C [l/min]
I38 Temperature calorifier sensor B10 P1/P2 [°C]
I39 Temperature calorifier B11 P2 / P3 [°C]
System info
I40 Daily switch cycle counter burner 0...999
I41 Daily operating hours counter burner 0...255 h
I42 Switch cycle counter burner [x 1000]
I43 Operating hours counter burner [h x 100]
I44 Software version (v = Version; r = Revision) v.r
I45 Time since last service [h x 10]
E ES SC C
= exit menu
6.3.2 Info mode
Here, specific system values can be displayed.
By turning the dial knob, the individual operating status
values can be interrogated.
Each value can be assigned to the next list via a row
number.
➩
Entries in column “Limited display” show the relevant
configuration or the relevant features, for which the
value is displayed. Resetting temporary information
☞
The daily counters I40, I41, the damped
external temperature I12 and the time since last
service I45 when displayed are reset by pressing the
key (approx. 2 seconds) .
Once I45 has been reset, the flashing spanner symbol
goes out.