© weinor GmbH & Co. KG
EN | 7
Fault
Cause
Remedy
No travel
command can
be issued via
the hand-held
transmitter
The wind alarm is active.
Wait until the delay
time has elapsed (15
minutes).
The batteries in the hand-
held transmitter are
fl
at.
Change battery
Motor has no power sup-
ply or is overheated
Check power supply
or allow motor to cool
down.
The blind does
not travel up
when it is
windy.
WIND threshold value is
set incorrectly
Adjust the WIND
threshold value.
The blind
doesn’t
travel down in
response to
sunshine
The LIGHT threshold
value is not exceeded.
Adjust the LIGHT
threshold value
Wind alarm is active
Wait until the delay
time has elapsed (15
minutes).
Rain alarm is active
Wait until the delay
time has elapsed (15
minutes).
Roller shutter mode is not
supported by the receiver.
Change the mode
The transmitter is set to
MANUAL mode.
Set the transmitter to
AUTOMATIC mode.
Poor radio connection
Change the position
of the device.
Light sensor is dirty
Clean light sensor
The device
cannot be
programmed to
recognize the
receiver
Device is already pro-
grammed
Delete the device and
re-program it
Poor radio connection
Change the position
of the device.
The blind
doesn’t
travel down in
response to
darkness
The twilight threshold
value is set incorrectly.
Adjust the twilight
threshold value.
The twilight function is not
supported by the receiver.
Use a different
receiver.
The blind
travels down
when it is
windy.
Device is improperly pro-
grammed
Delete the device and
re-program it
All LEDs
fl
ash
Wind sensor is wet; device
is defective
Allow the wind sensor
to dry
Repair
Please contact your dealer if you have any queries.
Repair
