Testing method for two or more IE-WL-AP-BR-CL-ABGs
If you have two or more IE-WL-AP-BR-CL-ABGs, you will need a second
notebook computer (B) equipped with an Ethernet port. Use the default
settings for the first IE-WL-AP-BR-CL-ABG connected to notebook A, and
change the second or third IE-WL-AP-BR-CL-ABG connected to notebook
B to Client mode and then configure the notebooks and
IE-WL-AP-BR-CL-ABGs properly.
After setting up the testing environment, open a DOS window on
notebook B. At the prompt, type
ping IP address of notebook A
and then press
Enter
key. A “Reply from IP address …” response means
the communication was successful. A “Request timed out.” response
means the communication failed. In this case, recheck the configuration
to make sure the connections are correct.
Panel Layout of IE-WL-AP-BR-CL-ABG
1.
Grounding screw
2.
Terminal block for PWR1, PWR2,
relay, DI1, and DI2
3.
Reset button
4.
Heat dissipation orifices
5.
System LEDs: PWR1, PWR2,
PoE, FAULT, and STATE LEDs
6.
LEDs for signal strength
7.
WLAN LEDs: CLIENT BRIDGE,
and WLAN LEDs
8.
RS-232 console port
9.
10/100BaseT(X) RJ45 Port
10.
10M LED
11.
100M LED
12.
MAIN antenna port
13.
AUX antenna port
14.
Article number
15.
Screw hole for wall mounting kit
16.
DIN-Rail mounting kit
Front Panel View
Rear Panel View
Top Panel View
- 4 -
