18
41. Wrap the Carriage Cable (83) around a 90mm
Pulley (15). Attach the Pulley and a pair of Pulley
Covers (40) to the first set of holes from the bot-
tom of the two Large Pulley Plates (91) with an
M10 x 52mm Bolt (12) and an M10 Nylon Locknut
(21). Make sure the small tabs on the Pulley
Covers are on bottom.
43. Wrap the Carriage Cable (83) around a 90mm
Pulley (15). Attach the Pulley and a pair of Pulley
Covers (40) inside the bracket on the Right
Upright Bracket (93) with an M10 x 52mm Bolt
(12) and an M10 Nylon Locknut (21). Make sure
the small tabs on the Pulley Covers are on the
bottom.
44. Attach the Carriage Cable (83) to the Carriage
(89) with an M10 x 22mm Bolt (98) and an M10
Nylon Locknut (21).
42. Wrap the Carriage Cable (83) under a 90mm
Pulley (15). Attach the Pulley and a pair of Pulley
Covers (40) inside the other bracket on the
Stabiliser (5) with the M10 x 105mm Bolt (106)
used in step 40, and an M10 Nylon Locknut (21).
Make sure the small tabs on the Pulley Covers
are on top.
41
42
43
44
12
21
91
40
40
15
83
Small
Tab
40
40
15
106
21
5
83
Small
Tab
Small
Tab
40
40
12
93
15
83
21
21
89
83
98
11
15. Lubricate the axles on the Top Frame (55) with
grease. Orient the Right Butterfly Arm (48) as
shown and slide it onto the right axle. Make sure
the Butterfly Arm is behind the bracket on the
Top Frame.
Have a second person secure the Right Butterfly
Arm (48) to the axle with two 25mm Retainers
(68) and a 25mm Cover Cap (65). Note: Place
the Retainers on top of the inverted Cover
Cap, as shown in the inset drawing; make
sure the teeth on the Retainers bend toward
the Cover Cap. Gently tap the Cover Cap onto
the axle.
Repeat this step with the Left Butterfly Arm
(47).
15
47
Lubricate
Axle
Bracket
65
65
48
55
68
68
Axle
Cable Assembly
16. For cable identification and routing during
steps 16 to 44, refer to the CABLE DIAGRAMS
on page 25. Do not overtighten the locknuts
securing the pulley; the pulleys must be able
to roll easily.
Locate the High Cable (11), which has a ball on
one end and an eyelet on the other. Route the
eyelet end of the Cable up through the Top Frame
(55) and around a “V”-pulley (6). Attach the “V”-
pulley inside the Top Frame with an M10 x 78mm
Bolt (76), two 12.5mm Spacers (82), two M10
Washers (9), and an M10 Nylon Locknut (21).
16
6
11
55
21
76
9
9
82
82
17. Wrap the High Cable (11) around a “V”-pulley (6).
Attach the “V”-pulley and a Long Cable Trap (50)
to the bracket on the Top Frame (55) with an M10
x 60mm Bolt (7) and an M10 Nylon Locknut (21).
Make sure the Cable Trap is oriented to hold
the Cable in the groove of the “V”-pulley.
17
55
11
7
50
21
6
Small
Tab
