30
WWW.WEBER.COM
®
ROUTINE MAINTENANCE
MAINTAINING THE ELECTRONIC
CROSSOVER
®
IGNITION SYSTEM
The igniter module supplies power to the electronic
Crossover
®
ignition system and the side burner with
one igniter button. Whether you are performing routine
maintenance or a troubleshooting check on the ignition
system, read the following to keep your ignition system
working properly.
If the electronic Crossover
®
ignition system fails to ignite,
you'll need to pinpoint where the problem is occurring:
with the gas flow or with the electronic ignition system.
Begin by attempting to match light your burners. Refer
to “MAIN BURNER IGNITION - Lighting with a Match.”
If match lighting is successful, the problem lies in the
ignition system.
• Verify that the AA battery (alkaline only) is in good
condition and is installed correctly
(1). Some batteries
have a plastic protective wrap around them. This
plastic must be removed before installing battery. Do
not confuse this plastic with the battery label.
• Make sure the igniter wires are properly attached to
the igniter module. Refer to the “IGNITER MODULE
WIRE GUIDE” chart on this page.
• Make sure the ceramic igniter assembly is fully
inserted into burner tube igniter channel
(2). If properly
positioned, you will hear a snap
(3).
• Make sure the electronic igniter button is working by
listening for clicking and looking for sparks at burner.
If the electronic Crossover
®
ignition system still fails
to ignite, contact the Customer Service Representative
in your area using the contact information on our web
site. Log onto www.weber.com
®
.
1
2
3
IGNITER MODULE WIRE CHART (E220 / E320 / SP320)
1
2
1
2
5
6
3
4
3
4
5
6
BURNER 1
SIDE BURNER
IGNITER BUTTON
Black Terminal
(1)
Blue Terminal
(3)
Black Terminal
(5)
Yellow Terminal
(2)
Green Terminal
(4)
Black Terminal
(6)
