Weather-Rite TT Series, Installation, Operation & Service Manual

Page: 66 / 205

TT-S
ERIES
I
NSTALLATION
, O
PERATION AND
S
ERVICE
M
ANUAL
60 of 198
SECTION 13: INLET HOODS
Inlet hoods are a v aila b le w ith permanent filters or b irdscreen mo u nted on the inet face.
For models TT112 - TT215, inlet hoods are shipped as one piece. For models TT218 and TT221 the inlet
hood is shipped in t
w o pieces. For models TT224 and TT230, inlet hoods are shipped as fi v e pieces. For
models TT233 and TT236 are shipped in t w o sections.
The inlet hood may b e installed either onto the inlet of the air handler or to an o u tside w all. After installing an
inlet hood, all hard w are m u st b e tightened w ith a torq u e w rench to recommended specifications on Page 10,
Table 1 . In addition, all seams m u st b e ca u lked (s u pplied b y others).
Crush Hazard
Use proper lifting
equipment and
practices.
Falling Hazard
Use proper safety
equipment and prac-
tices to avoid falling.
Severe Injury Hazard
Use proper lifting
practices and equip-
ment.
Equipment and
accessories are
heavy.
Cut/Pinch Hazard
Wear protective gear
during installation,
operation and
service.
Edges are sharp.
WARNING
Failure to follow these instructions can result in death, injury or property damage.