UP35-4481N26000-02/15
– REV.B1
Page 52 / 63
7.4
Mounting of respecitve tool head into the designed adapter
DANGER
Due to the risk of hand or finger injury, never try to reach into the machine before having
assured that the machine is disconnected from the air supply. Disconnect the air supply
before changing the safety guard, the adapter or the dies.
CAUTION
+
The crimp machine is only allowed to be used with mounted dies, die adapter and the
suitable safety guard. Pay attention to the correct assignment of adapter to safety guard.
+
The crimp machine is only allowed to be used when it is in a completely functional
condition.
+
Before commissioning the machine, it is always important to check whether all safety
devices, especially the safety guards and die adapter, are installed and are functioning
correctly.
+
When working with the pneumatic Parallel Crimp Machine UP 35, do not wear loose
clothing, jewellery or long, loose hair that can get caught in the pneumatic Parallel Crimp
Machine UP 35.
+
Work with caution.
+
Only one person is allowed to work on or with the machine at a time.
+
Only trained personal are allowed to work on or with the machine.
+
Assure free access to the operating elements of the machine, especially the foot pedal
and the release button. In the case of imminent danger immediately press the release
button. The release button must be within the direct reach of the operator. It must not be
covered.
+
It is only allowed to work with the specified air pressure.
+
Extract the upper and lower part of the
adapter as far as possible.
+
Choose the correct tool head.
+
Unlock and extract the pins
1
until stop.
+
Mount the tool head into the lower part of
the adapter and press the pins
1
until
stop.
INFORMATION
+
Control the right position of the die
halves! The size of the profile should be
in line!
+
Slide the upper and lower adapter together.
Fig. 7.6
Fig. 7.7
1
