Automatic sauna splash system, Sauna Plus 8
Index: 05 Change date: 11.09.2018
Operating instructions no.: BA DW 003-05 Sauna Plus 8 EN 24+230V.docx
Page 13 of 76
connection 4x1 mm - 3/8“ external thread.
ATTENTION !
The composition of the fragrance varies. This may reduce the
service life of the hoses in the hose pumps. It is therefore necessary
to check the hose pumps on a regular basis according to the
maintenance plan.
Control unit
The control unit has a housing of protection class IP44. All electronic components
are installed in it. The touch panel on the control unit can be used to set the
operating parameters.
Control signals for external consumers / attractions
The following control signals are available for controlling external consumers.
1.
Control signal for sauna heater, floating.
The controller of the automatic sauna splash system provides a signal to control
the sauna heater before a splash to ensure that the splash is not provided onto
the unheated heater.
2.
Sound effect, floating.
This signal can be used to trigger a sound effect during the splash pre-indication
and/or the splash.
3.
Fault message, floating
This signal can be used to send a fault message to an external GLT.
4.
Sauna splash pre-indication, 230 V
This signal can be used to control a light signal within or outside the sauna in
order to announce the splash.
5.
Effect illumination, 230V
This signal can be used to trigger a light effect during the splash pre-indication
and / or the splash.
Also see the terminal plan in
Section 9.2.
Avoid splash onto a cold heater
There are two options for preventing the first splash onto a cold heater:
Option 1 (switch-on delay)
Activating the switch-on delay makes it possible to set a delay (0-30 min) for the
first sauna splash (see
Section 6.5.2 Splash
switch-on delay)
.
Option 2 (pre-heat the sauna heater during operation)
The sauna heater control signal (for external consumers) makes it possible to set a
pre-heating time (0-180 sec) for the sauna heater. The sauna heater is then heated
