8
7150 143rd Avenue NW
Ramsey, MN 55303
Tel: (763) 427-9638
Toll Free: (866) 405-1268
www.watercontrolinc.com
Manufactured by:
W
ater
C
ontrol
C
orporation
System Activation and Flushing
7150 143rd Avenue NW
Ramsey, MN 55303
Tel: (763) 427-9638
Toll Free: (866) 405-1268
www.watercontrolinc.com
Manufactured by:
W
ater
C
ontrol
C
orporation
System Activation and Inspection
1. Check all tubing connections to ensure they are firmly seated. CHECK TO SEE THAT THE CARTRIDGE RETAINER CLIP IS
PROPERLY ENGAGED AND LOCKED. Failure to keep the retaining clip in place will result in accidental leaks and flooding.
2. Open the dispensing faucet at the sink. Close the tank shut-off valve. Make sure the angle stop valve for the incoming
water is open. Open the small feed shut-off valve on feed valve assembly.
3. Observe all tubing and connections for several minutes to detect any leaks. In approximately 5 minutes, (assuming
normal feed water pressure) the dispensing faucet should begin dripping.
4. Allow the faucet to run for up to 15 minutes, then close the faucet.
5. Check for leaks at all connections.
6. Open the tank shut-off valve.
Initial Flushing Procedure
1. Before the system can be used for drinking water production it must be adequately flushed. Each reservoir tank is
dosed with a small amount of powdered sanitizer before shipment, typically a chlorinating agent, in order to ensure tank
internal cleanliness. Also, the carbon filter cartridge will release a small amount of carbon fines during the first tankful of
flow. This flushing procedure will allow any sanitizer or carbon fines to pass from the system.
2. Initial tank filling will take approximately one hour (based on average feed pressure). When the tank is full, the water
pressure will have risen to the point where the automatic shut-off valve inside the system will stop the feed flow through
the system. Actuation of the automatic shut-off valve can be determined by either checking for a lack of brine flow to the
drain saddle, or by listening very closely near the dispensing faucet for absence of water flow sound though the air gap.
When the tank has filled for the first time, it should be left undisturbed for at least 8 hours to ensure proper sanitization.
3. After 8 hours has elapsed, open the dispensing faucet fully and allow the product water to run out to drain at maximum
flow. The initial discharge will be dark with the bulk of the carbon particle wash out. There may also be the scent of chlo
-
rinated water from the sanitizing agent. When the flow has diminished to a fast drip or small stream, close the dispensing
faucet.
4. Fill and flush the tank at least three times prior to use. If necessary, repeat until the chlorination scent has disappeared.
It is important that the flush be done at maximum flow (e.g. the tank must be full) to assist in rapid wash out. After this
flushing procedure the system is ready for normal use.
Water Control Corporation
7150 143rd Ave NW Ramsey, MN 55303
Phone: 866-405-1268 Fax: 763-427-5665
www.watercontrolinc.com
© Water Control Corporation 0820
