WCC PS-5 Series Manual Download Page 6

6

7150 143rd Avenue NW

Ramsey, MN 55303

Tel: (763) 427-9638

Toll Free: (866) 405-1268

www.watercontrolinc.com

Manufactured by:

W

ater

C

ontrol

C

orporation

Push Handle Airgap Faucet

7150 143rd Avenue NW

Ramsey, MN 55303

Tel: (763) 427-9638

Toll Free: (866) 405-1268

www.watercontrolinc.com

Manufactured by:

W

ater

C

ontrol

C

orporation

Product water 

 

(3/8" blue tubing)

System to airgap drain 

(1/4" black tubing)

Faucet to drain saddle

 

(3/8" white tubing)

Metal base plate

Rubber seal

1

2

3

5

6

4

Note:  This faucet requires a 1¼" opening in the sink or countertop.

1. Locate the faucet parts bag and arrange the parts on the

countertop in the sequence shown.

2. The last part in the sequence, the quick connect adapter (6),

will be found in the smaller parts bag.

3. Locate the piece of white tubing.  Pull the white, black and

blue tubing up through the faucet hole in the sink.

4. Insert polished faucet base and rubber seal onto base of

faucet.

5. Push the 1/4” black drain tubing attached to the system onto

the smaller 1/4” barb located on the faucet base.

6. Push the 3/8” white tubing onto the larger 3/8” fitting located

on the faucet base.

7. Slide white plastic spacer open-end-up onto the threaded

faucet stem (2). Note: This spacer may be omitted it faucet is

installed in a granite countertop (or countertop with similar

thickness).

8. Loosely thread the 3/8" washer (3), the serrated washer (4)

and mounting lock nut (5) onto the threaded stem.   Leave enough

space for the slotted washer which will be used in step 11.

9. Thread faucet quick-connect adapter (6) on to threads of

faucet stem. NOTE: This connection should be hand-tightened only.

Push one end of 3/8" blue tubing into 3/8" connection.

10. Push the tubing down into the faucet hole and position the

faucet to the approximate orientation.

11. From underneath the sink, slip the slotted washer (1) between

the white plastic spacer and the sink. Check the orientation of

the faucet on the sink.  Securely tighten the mounting nut with a

wrench.

12. If necessary, firmly insert spout assembly into

 

the top hole of

faucet body (approximately 1/4").  You may swivel the faucet left or

right.

Water Control Corporation
7150 143rd Ave NW  Ramsey, MN 55303

 

Phone: 866-405-1268  Fax: 763-427-5665

 

www.watercontrolinc.com
© Water Control Corporation 0820

Summary of Contents for PS-5 Series












Reviews: