Way Train 250S, Instruction Manual

Page: 7 / 43

D. WORKING ENVIRONMENT:
(1). KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.
(2). DON'T USE IN DANGEROUS ENVIRONMENT. Don't use power tools in
damp or wet locations, or expose them to rain. Keep working area well-lighted.
(3). KEEP CHILEREN AND VISITIORS AWAY. All children and visitors
should be kept a safe distance from work area.
(4). DON’T install & use this machine in explosive, dangerous environment.
E. MAINTENANCE:
(1). DISCONNECT machine from power source when making repairs.
(2). CHECK DAMAGED PARTS . Before further using of the tool, a guard or
other part that is damaged should be carefully checked to ensure that it will operate
properly and perform its intended function. Check for alignment of moving parts,
binding of moving parts, breakage of parts, mounting, and any other conditions that
may affect its operation. A guard or other part that is damaged should be properly
repaired or replaced.
(3). DISCONNECT TOOLS before servicing and when changing accessories such
as blades, bits, cutters, etc.
(4). MAKE SURE that blade tension and blade tacking are properly adjusted.
(5). RE-CHECK blade tension after initial cut with a new blade.
(6). TO RPOLONG BLADE LIFE ALWAYS release blade tension at the end of
each workday.
(7). CHECK COOLANT DAILY Low coolant level can cause foaming and high
blade temperatures. Dirty coolant can clog pump, cause crooked. Rust, low cutting
rate and permanent blade failure. Dirty coolant can cause the growth of bacteria with
ensuing skin irritation.
(8). WHEN CUTTING MAGNESIUM NEVER use soluble oils or emulsions
(oil-water mix) as water will greatly intensify any accidental magnesium chip fire.
See your industrial coolant supplier for specific coolant recommendations when
cutting magnesium.
(9). TO PRNMT corrosion of machined surfaces when a soluble on is used as
coolant, pay particular attention to wiping dry the surfaces where fluid accumulates
and does not evaporate quickly, such as between the machine bed and vise.
F. SPECTIFIED USAGE:
This machine is used only for general metals cutting within the range of cutting
capacity.
5