Wavion WS410, Installation Manual

Page: 33 / 66

Installing the Wavion WS-410 Metro Access Point
Installation Guide 33
4.
Connect the NEMA 3 prong plug from the Wavion WS-410 to the photosensor connector on
the streetlight.
5.
Connect the photosensor to the top of the NEMA 3 prong plug.
6.
Connect the AC plug to the WS-410 and tighten by hand.
7.
Reenergize the circuit and confirm that the power to the WS-410 comes on.
Connecting a Data Port
The Wavion WS-410 is equipped with four RJ45 connectors. The bottom two ports are for
engineering use only. Typically, you will connect to the ETH A port. Use the ETH B port if you
are connected to a backhaul unit for which you have to supply power. Only one port is active
at any time.
N
OTE
:
The Wavion WS-410 is equipped with additional AC surge protection and fuse
branch circuit protection. AC current protection of 20Amp should be installed.
N
OTE
:
Do not leave connectors open to the environment. Cover connectors with the
closure cap when not in use and tighten the cap. See Chapter 7: Installation
Accessories on page 53 .
N
OTE
:
Use only shielded Cat5e cable rated for outdoor use.
See Chapter 7:
Installation Accessories
on page 53
for details.
The shields of the Cat5 cable
must be properly terminated and bonded to the unit and to the protective earth (PE)
at the building entrance. This provides protection against the risk of fire, electrical
hazard and ensures the reliable operation of this equipment,
N
OTE
:
National Electrical Codes (NEC) Article 800 requires the use of an Agency
Listed (UL/CSA) Building Entrance Protector for all power and communications cables
entering a building. Article 800 is intended to protect the building and occupants
from fires caused by transient voltage and current surges.
W
ARNING
:
DC voltage may be present on Ethernet B pins 4,5 (+) and 7,8 (-)
N
OTE
:
This is not a mid-span powered device. Do not attempt to daisy-chain Power
Over Ethernet devices.