18
Note:
If the RMS is configured with DHCP disabled and the IP address assigned to the RMS is
incompatible with the LAN that the RMS is connected to, when you click the the record of the
discovered RMS, a popup window will occur that tells you that you need to reset the RMS to DHCP
mode.
Note:
The RMS ships with DHCP enabled. If the LAN that the RMS is connected to does not allow UDP
broadcast packets, then the WaveWare Discover and Reset Tool will not discover the RMS. Refer to
Troubleshooting section for how to address this issue.
Log Into RMS
Once you click on the discovered RMS, if there are no IP address configuration problems, you should be
prompted for userid and password in the browser. The Master Userid value is defined by a label on the
RMS unit, and the default password value is blank. In addition, the RMS ships with a default userid value
of admin and a default password RMSpass1234.
A successful login will cause display of the RMS main page
in the browser. The drop down menus and main page
contents are filtered by the Role assigned to the user
account. The default user account is assigned a Role
value of Super, which provides full configurability. Any
other Role assignment only causes display of the drop
down menu bar.
Configuration is described in more detail below. You are
also offered a link for downloading the RMS manual,
which requires internet access.
You can identify the system version number by clicking About in the RMS web config menu. You can
observe the Master Userid value once you log in by opening the General Settings web config page.
