7 of 13
WX-501-0531 • 01.22
Setting
Description
Baud Rate
Allows you to change the baud rate at which the device connects to the sensor.
Flow Control
Is used for configuring hardware handshaking. This option is currently not available.
Parity
Allows you to set parity error checking.
Stop Bits
Allows you to set the number of stop bits.
Data Bits
Shows you the number of data bits being sent. This option cannot be changed.
Active Port
Indicates on which port you are communicating with the sensor. This option cannot be changed.
Latency
Indicates the latency between the sensor and the Click device. This option cannot be changed.
The
System > Autobaud
tab allows you to configure how the device autobauds (see the figure and table below).
Setting
Description
Command
Allows you to set the command sent from the device during the autobaud process. Don’t change
these values unless instructed to by Wavetronix Technical Services.
Response
Shows the response the device is expecting from the above command. Don’t change these values
unless instructed to by Wavetronix Technical Services.
SmartSensor ID
Shows the ID number of the sensor with which the Click device is currently communicating. This
only shows the number after you have autobauded the Click device; when the Click device is not
communicating with a sensor, this option will display a 1.
Server/Client
Allows you to set whether the device is a server or client. (This option is not related to device
autobauding.)
The
Ethernet > General > Network
tab allows you to configure network settings (see the figure and table below).
