15
Getting the parts set up
Refer to the diagram to the right as needed
1. Connect the two SMA Pigtail cable adapters to the Cel-Fi GO G41 amplifier.
2. Note the two icons by the Cel-Fi GO G41’s two SMA antenna ports:
This port should be plugged into the indoor antenna(s).
This port should be connected to the outdoor antenna.
3. Connect the RS400 cables to the SMA pigtail adapters and hand-tighten them.
4. If you have a kit with 2x, 3x, or 4x indoor antennas, connect your splitter to the indoor
antenna end of the booster using the 1 ft jumper.
5. Connect the 30 ft cable(s) and panel/dome indoor antenna(s) to your splitter or directly to
the indoor antenna port of your Cel-Fi GO G41 and hand-tighten the connectors.
6. Connect the Outdoor Antenna to the 5 ft RS200 cable, Lightning Surge Protector, and
RS400 cable. Instructions on grounding are in the next section of the manual and can also
be found online at
waveform.com/surge-protector
7. Connect the Cel-Fi GO G41 power supply and plug it into the booster.
Assembling the UltraPole and Antenna
The photo to the right shows how your outdoor antenna should be
secured to your UltraPole mount.
If you’d like more detailed instructions for installing your outdoor
antenna and assembling your UltraPole Base Kit, please refer to it's
included manual or view it online at
waveform.com/ultrapole
If your kit also includes the Grid Parabolic outdoor antenna, please
refer to it's included manual
for it's assemble instructions
.
You can
also find those instructions online at
waveform.com/griddy
09
Assembling Your Kit