WAVECOM Decoders v6.15 W40PC, W41PC, W51PC
Install & Uninstall
•
33
Configuring the connection parameters requires that you
Disconnect,
if you are connected.
The following setup parameters are available:
•
This Computer
or
Remote Computer.
If you work with your
local computer, the local address will be used. If you connect to a
remote computer, Remote Computer Name or IP Address, TCP
port and the speed limit must be set (see below).
•
Remote Computer Name or IP Address
•
TCP Port
. Enter the port your server is listening. The default
value for the WAVECOM server is 33133. Your client can only
connect to the server if they are working on the same port.
•
Speed Limit
. Select one of the available speeds (range 9600 baud
up to 10M). According to the speed the update of the screen and of
the tuning display is controlled.
Each W51PC card is identified by a unique serial number. Thus the W51PC software is able to
search for W51PC cards automatically. This functionality is available for both a local and a
remote computer. Pressing the "
Connect
" button will start the process.
The selected entry is stored in the card’s initialization file (*.ini file) and no further entry is
necessary when the W51PC software is started later again. The settings may be changed at any
time.
The W51PC system can be used in a network configuration. This allows the system to be
controlled remotely.
Summary of Contents for W40PC
