2
Introduction
For maximum performance and reliability, please follow the simple
instructions in this manual .
Package Contents
Examine the components carefully to make sure no damage has
occurred to the Permeate Pump . Care should be taken to ensure
the pump is not dropped or mishandled; dropping will damage the
pump .
Package contains the following:
• (1) Permeate Pump with mounting clip
• (2) Quick-Connect Reducer Union
• (2) 3" long,
1
⁄
4
" Blue tubes
• (1) 48" long,
1
⁄
4
" Blue tube
• (1)
3
⁄
8
" Quick-Connect Union Tee
• (1)
1
⁄
4
" Quick-Connect Union Tee
• (1)
3
⁄
8
" Plug Insert
• (1)
1
⁄
4
" Plug Insert
How to use the Quick-Connect fittings on the RO Module
To make a connection, the tube is simply pushed into the fitting .
Place a piece of tape
1
⁄
2
" from end of tube to indicate how far the
tube should be inserted . The unique Watts Quick-Connect locking
system holds the tube firmly in place without deforming it or restrict-
ing flow .
Cut the tube square . It is essential that the outside diameter be free of score marks
and that burrs and sharp edges be removed before inserting into fitting .
Fitting grips before it seals . Ensure tube is pushed into the tube stop .
Push the tube into the fitting, to the tube stop. The collet (gripper) has stainless
steel teeth which hold the tube firmly in position while the O-ring provides a perma-
nent leak proof seal .
Pull on the tube to check that it is secure . It is a good practice to test the system
prior to leaving site and /or before use .
To disconnect, ensure the system is depressurized before removing the tube . Push
in collet squarely against face of fitting . With the collet held in this position, the tube
can be removed . The fitting can then be reused .
