Watts LYNC UV-H, Installation, Operation & Maintenance Manual

Page: 7 / 40

LYNC UV-H
SECTION 3: PRODUCT SPECIFICATIONS
• • •
SECTION 3: PRODUCT SPECIFICATIONS
Specifications & Features common to all units
Operating Pressure
1
5-100 psig (34-690 kPa)
Water Temperature Range
2
34-104 ° F (1-40 ° C)
Air Temperature Range
2
34-104 ° F (1-40 ° C)
Maximum Relative Humidity
3
70%
Voltage Input 120Vac 50/60Hz for North America.
230 or 240 Vac 50/60Hz for International.
See power input label on left side of unit near power cord.
Manifold materials 316 Stainless Steel
External Contact 2 available - Standard
Remote Start/Stop Standard
Data Logging to USB Drive Optional on all units
Automatic Solenoid Shutoff Valve Optional on all units
Wetted Parts Meets NSF/ANSI/CAN 61 & NSF/ANSI 372
1
Purging requires pressure to work properly. The optional shutoff valve requires min. 8psig (55kPa) to operate.
2
In extreme conditions, high air temperatures may require lower temperatures for proper operation and vice versa.
3
For continuous flow potable applications, it is recommended to dehumidify the room where the UV unit is located.
4
Certified by WQA to 73
°
F or 23
°
C
Flow restrictors limit the water flow through the UV unit despite the demand or the amount of supply
pressure. A flow restrictor is mandatory for an NSF/ANSI 55 Class A system but optional for other units.
Warning: Removal of this device may allow the water flow to exceed the validated performance of the
system which therefore may not provide the necessary UV dose for effective treatment.
Potable Water
Lync UV-H Models
Hallett
1000P
Hallett
750PN Hallett
750P
Hallett
500PN Hallett
500P
Max. Flow Rate
1
100 gpm 27.4 gpm 40 gpm 16.5 gpm 37 gpm
Performance Certifications
2
NSF/ANSI 55
Class A
NSF/ANSI 55 Class
A
Min. UVT for 40mJ/cm
2
Dose 95% 75% 95% 75% 95%
Flow Restrictor Optional Yes Optional Yes Optional
Pressure Drop 5 psi 22.7 psi
3
13 psi 22.7 psi
4
10 psi
Lamp Type Amalgam LPHO LPHO LPHO LPHO
Lamp Life
5
16 months 12 months 12 months 12 months 12 months
Cycles/day
6
6-12
2 (I.S.)
6-12 (P.H.)
2 (I.S.)
6-12 (P.H.)
2 (I.S.)
6-12 (P.H.)
2 (I.S.)
6-12 (P.H.)
UV Sensor Quad Dual Dual Dual Dual
Built-in Purge Valve Standard Standard Standard Standard Standard
Automatic Quartz Sleeve Cleaning Device Standard Standard Standard Standard Standard
Wiper Position Switch Standard Standard Standard Standard Standard
Lamp Heaters No Standard Standard Standard Standard
4-20mA Output Optional Optional Optional Optional Optional
Modbus connectivity Optional Optional Optional Optional Optional
Power Draw 403W 222W 222W 196W 196W
Inlet & Outlet Port size 2" MNPT 1" MNPT 1" MNPT 1" MNPT 1" MNPT
Nominal Dimensions
(H x W x D) 56x11x9"
(142x29x 22cm)
40x10x9"
(103x24x 22cm)
40x10x9"
(103x24x 22cm)
36x10x9" (93x24x
22cm)
36x10x9"
(93x24x 22cm)
1
Based on UV Dose of 40mJ/cm
2
at alarm setpoint.
2
NSF/ANSI 55 Class A certifications substantiated by NSF International only. Third party validations are pending.
3
The flow restrictor adds significant pressure drop so the value presented is at 75% of maximum flow capacity.
4
The flow restrictor adds significant pressure drop so the value presented is at 75% of maximum flow capacity.
5
Amalgam lamp lifetime is 12,000hrs/500 days and LPHO lifetime is 9000hrs/375 days.
6
Instant Start (I.S.) LPHO limited to 2 cycles/day; Preheat (P.H.) models have 6-12 cycles/day. Exceeding the recommended daily cycles will
accelerate the age of the UV lamps. LPHO lamps perform more reliably when operated 24/7.