Watts H2O-DWRO300, Installation, Operation And Maintenance Manual

Page: 8 / 52

Page 8
If you have a garbage disposal, do not install the drain saddle near
it. Installation of the drain saddle must be either above the garbage
disposal, or if a second sink drain is available, install it above the
cross bar on the second drain. Installation of the drain saddle near
a garbage disposal may cause the drain line to plug.
Drain Saddle fits standard 1 ¼" – 1 ½" drain pipes
Drain Saddle Installation
CAUTION !
1 Semicircle bracket with opening 2 Screws
1 Foam gasket 2 Nuts for screws
1 Semicircle bracket
Step 1
- Gather the pieces of the drain saddle
Step 1
- Turn off the cold water supply to the faucet by turning
the angle stop valve completely off.
Step 2
- Open cold water sink faucet to relieve pressure.
Step 3 -
Disconnect the Faucet Line from the Cold water
supply.
Step 4 -
Choose the configuration that fits your plumbing
needs and attach Adapt-a-Valve
TM
as instructed and
illustrated below.
Option 1: 3/8" Configuration (diagram to left)
a. Attach Brass adapter (A) to Faucet line
b. Attach the male end of the Plastic Adapt-a-Valve & Black
Collet (B) to the female end of the Brass Adapter (A)
c. Insert the White Rubber Washer (C) into the opening of Brass
Adapter with no washer (D)
d. Attach the Brass Adapter/White Rubber Washer Assembly
into the female end of the plastic Adapt-a-Valve & Black
Collet (B)
e. Attach the female end of the Adapt-a-Valve and brass adapter
assembly into the male end of the cold water supply
Option 2: 1/2" Configuration (diagram to right)
a. Attach the Male end of Adapt-a-Valve and Black Collet (B)
into the Female end of the cold water supply
b. Attach the Male End of the Faucet Connection into the
Female end of the Adapt-a-Valve and Black Collet (B)
Parts List for Adapt-a-Valve
Item Description
A Brass Adapter with black washer
B Plastic Adapt-a-Valve & black collet
C White Rubber Washer
D Brass Adapter with no washer
NOTICE
NOTICE
NOTICE
Adapt-a-Valve Installation
Water supply line to the system must be from the cold water supply
line only. Hot water will severely damage your system.
Make sure that the black collet is installed into the 1/4" opening
on the Adapt-a-Valve. Don’t forget to install the white compression
washer with the 3/8" configuration. The Brass Adapters do not need
to be tightened with a wrench, only finger tight.
Do not use Teflon tape with the Adapt-a-Valve™.
D
B
Line from
Cold Water
Supply
Faucet
Connection
Faucet Line
Cold
Water
Supply
C
B
A
D
B
Line from
Cold Water
Supply
Faucet
Connection
Faucet Line
Cold
Water
Supply
C
B
A
For 1/2" Configuration
(Option 2)
For 3/8" Configuration
(Option 1)