Page 9
Step 20
Green Tube Connection - Feed Water
Step 19 Connect the green tube to the RO Module quick connect elbow
on the left side of the unit. Remove a brass nut, plastic sleeve and
brass insert from the parts bag. To assemble, place the brass nut
on the green tube first, then the sleeve (small tapered end of sleeve
must point to the end of tube) and then push the brass insert all the
way into the end of the tube. (See Picture)
Insert the green tube into the ¼” opening on the adapt-a-valve until
it stops. Slide the brass nut and sleeve down and thread onto the
male pipe threads. Use a ½” wrench to securely tighten the nut.
Thread the plastic valve onto the tank fitting.
Do not over tighten or the valve could crack.
Step 1
Step 2
Teflon tape must be applied in a clockwise direction. Wrap 5 to 7
turns around the male pipe threads (MPT) on the Stainless Steel
fitting on top of the tank.
Tank Valve Installation - Metal Tank
Tank Valve Installation - Plastic Tank
Thread the plastic valve onto the tank fitting.
Do not over tighten or the valve could crack.
Step 1
Step 2
Make sure the O-ring is located at the bottom of the recess for the
tank connection.
Reverse Osmosis Module Mounting
Step 21 Determine best location for the RO module to be mounted to allow
for future system maintenance. The parts bag has 2 self tapping
screws. Using an electric drill with a Phillips bit, screw them into
the cabinet wall 6” apart and 16” from the bottom of the cabinet.
Yellow Tube Connection - RO Module to Storage Tank
Step 2
Position the storage tank in desired location. Stand it upright or lay it on its side (using the black
plastic stand). Measure the yellow tube from Tee fitting to TANK and cut it to desired length.
Step 1
Locate the 3/8” Yellow tubing. Connect one open end to the Tee fitting on the final filter that is
clipped on to the RO Membrane housing.
Insert the open end Yellow 3/8” tube into the 3/8” opening on the tank ball valve.
Step 3
