Do not use auto restart for more than 12 times in 24 hours. We recommend
remote control where a high number of starts is required.
If the Auto restart feature is enabled it may cause the pump to start as soon
as power is turned on.
Auto-restart only affects operation of manual mode, network mode and
memodose mode.
If Auto restart is enabled the "!" Symbol is shown on the screen to warn users
that the pump may operate without any manual intervention (pump resumes
with previous settings).
Do not use auto restart for more than 12 times in 24 hours. We recommend
remote control where a high number of starts is required.
If the pump is configured to network mode or analog mode it will respond to
remote commands at any time including immediately after power on. The "!"
Symbol is shown on the screen to warn users that the pump may operate
without any manual intervention (e.g. a remote setpoint could start the pump
with no key press required).
The
!
symbol is a warning that the pump could remotely activate at any time. It will always be displayed
when the pump is in any remote control mode (analog and network mode). It will also be displayed
when auto restart has been enabled as the pump could activate after a power cycle, (auto-restart applies
to manual mode, network mode and memodose).
Flow units
The current chosen flow unit is displayed on the right hand side of the screen. To change flow units
move the selection bar over the flow unit menu entry and press
SELECT
.
94
m-630dun-en-08.2
Summary of Contents for 630 Du
Page 81: ...m 630dun en 08 2 81 ...
