Watlow PC1X-N20, User Manual

Page: 53 / 73

Active if factory password is
valid.
1700 r/w [`Off] idle
(0)
[`Off] idle (0)
[`req] request factory
mode (1)
[`act] factory mode
active (2)
[fcty] Factory Mode
Request
Requests factory
mode based on value
set in Factory Pass-
word prompt.
Active: Always. 1799 r/w [1234] [```0] to [9999]
(0 to 9999)
[`PW] Factory Password
Entry
Enter factory pass-
word.
[`pw]
Factory Password
[Fcty] Factory Page
This menu is used to set the password for the Power Series' Factory Mode.
Factory Mode
The Factory Mode parameters of the Factory Page are used for calibration of the Power Series.
Since the Power Series is precalibrated at the factory, field calibration may only be necessary in
the event that field service work is performed. Field calibration procedures are available at
Watlow’s website, http://www.watlow.com/.
NOTE: To enter the Factory Mode requires a password. Call Watlow at +1 (507) 454-5300, and ask an
applications engineer for this password. Once the password is entered, the controller is in Factory Mode. The
controller’s power must be cycled to exit the Factory Mode.
Active if retransmit option is
installed.
Factory mode only for write.
1555 r/w [```0] (0) [```0] to [4095]
(0 to 4095)
[rEtr] Retransmit Set
Test Word
Sets retransmit test
count.
Active if [``In] is not set to
[none] .
1581 r {----] {``LO] lo (0)
{``HI] hi (1)
{----] undeterminate
(2)
[`UAL] Read Selected
Input Value
Active: Always.
Factory mode only for write. 1580 r/w
{none] (0) {none] (0)
{pOS1] (1)
{pOS2] (2)
{pOS3] (3)
{)Cr1] (4)
{)Cr2] (5)
{)Cr3] (6)
[``In] Select Discrete
Input
Requests a display of
the state of the cho-
sen input.
Active: Always. 1513 r/w [idle] idle
(0)
[idle] idle (0)
{`req] enable display
test (1)
[dIsp] Display Test
Requests a display
test.
6 . 2 0
■
Wa t l o w P o w e r S e r i e s P a r a m e t e r s , C h a p t e r 6
Display Parameter Range Default Modbus Conditions for
(Modbus Value) Address Parameters to Appear
read/write