PM3/PM6 LEGACY™
Express PID Controller • 17 •
Keys and Displays
Menu and Keypad Basics
NOTE: You must read and understand the role of
each key on your controller keypad before proceed-
ing. Refer to the drawing and callouts on the previous
page. It is recommended to stop and spend some
time and practice the steps of navigating the
Operators and Set Up Menus on your controller
before proceeding with the instructions.
The instructions below will introduce you how to
navigate to frequently used areas of your controller.
Refer to the Operating and Set Up Menus listed on
the following pages for more detailed instructions.
NOTE: These diagrams might vary depending on the
Controller programming.
Introduction to the Set Up & Operating Menus
Upon power up, the display will default to the home
page in the Operations Menu. The upper red row
displays the process value (PV). The lower green
row displays the set point (SP).
Operations Menu
To enter the Operations Menu, press the Infinity Key
to return to the Home Page. Press the green
Advance Key
‰
to scroll through the various
prompts found in the Operations Menu. Press the
Infinity Key
at any point within the Operations
Menu to return to the Home Page. Use the Up and
Down Arrow Keys to increment or decrement settings
or change selection.
S
et Up Menu
To enter the Setup Menu press the Infinity Key
to
return to Home Page. Then press both Arrow Keys
for 6 seconds to enter the Set Up Menu.
Press the green Advance Key
‰
to scroll to the
prompt of choice.
Use Arrow Keys
to increment or decrement
settings or change selection.
At any point within the Setup Menu, push the Infinity
Key
to return to the Home Page.
The Operations Menu and the Set Up Menu are
further explained in detail on the following pages.
‰
[`
AUt
]
Autotune
[`
C;M
]
Control Mode
[`
h;pb
]
Heat Proportional Band
[`
C;pb
]
Cool Proportional Band
[``
ti
]
Time Integral
[``
td
]
Time Derivative
[
o;tb1
]
Time Base
[
o;tb2
]
Time Base
[`
A;lo
]
Alarm Low Set Point
[`
A;hi
]
Alarm High Set Point
[`
i;Ca
]
Calibratin Offset
‰
[`
loC
]
Lockout Menu
[`
SEn
]
Sensor Type
[`
Lin
]
Linearization
[``
t;C
]
Thermistor Curve
[``
r;r]
Resistance Range
[`
deC
]
Decimal
[`
C_F
]
Display Units
[`
r;lo
]
Range Low
[`
r;hi
]
Range High
[`
fn1
]
Function Output 1
[`
o;ty
]
Output Type
[`
fn2
]
Function Output 2
[`
h;ag
]
Heat Algorithm
[`
h;sC
]
Hysteresis (Heat & Cool)
[`
C;Ag
]
Cool Algorithm
[`
A;ty
]
Alarm Type
[`
A;hy
]
Alarm Hysteresis
[`
A;lg
]
Alarm Logic
[`
A;lA
]
Alarm Latching
[`
A;bl
]
Alarm Blocking
[`
A;si
]
Alarm Silencing
[
A;dsp
]
Alarm Display
[``
rp]
Ramp Action
[`
r;rt
]
Ramp Rate
[`
s;lo
]
Scale Low
[`
s;hi
]
Scale High
[
o;hi1
]
Power Scale High Output 1
[
o;hi2
]
Power Scale High Output 2
[`
Ad;s]
Zone Address
[
]
Bluetooth
btth
Set Up Menu
Operations Menu
