Watkiss Automation BookMaster, Service Manual

Page: 107 / 128

Installation • BookMaster Infeed Guide (BIG)
Watkiss BookMaster Service Manual - Issue 1 - 04/12/00
101
Fit the rear hand screw (see Figure 7:10) and then tighten the two side hand
screws.
Figure 7:10 Motorised infeed tray length adjustment
The length of the infeed tray can be adjusted using the length adjustment hand
screw (see Figure 7:10).
Fit the paper tray (see Figure 7:7) if required.
7.5.1 Using the BMI as a collecting station
The BMI can be used as a collecting station, so that sets/sheets are delivered
onto it, and only released on an external signal. This is implemented using the
Watkiss Vario collator on an Oscillating Floor Base.
Procedure
1. Using terminal emulator on the Vario, select OUT 5 (output 5, pause du-
ration, V6.5a onwards).
2. On the OFB PCB (900-166), set the directional link to position B.
3. On the Vario, set the batch size as required.
For further details on terminal emulator mode, please refer to the Watkiss
Vario Service Manual and to section 4.3.2 ‘‘Terminal Emulator Mode’’ in this
manual.
7.6 BookMaster Infeed Guide (BIG)
The BookMaster infeed guide is mounted on the top of the BookMaster
machine.
There are two clips that fix it in position. The R/H clip is fixed. The L/H clip
is spring loaded.
Position the R/H clip in the BookMaster infeed slot. Depress the L/H clip
against its spring and position it also in the BookMaster infeed slot.
7.7 BookMaster Offline Control Panel (BCP)
The Offline Control Panel is compatible only with the BookMaster Pro
(BMP), it is NOT compatible with the BookMaster Standard (BMS)
The BCP is fitted on the top edge of the BookMaster Pro in place of the black
curly communications cable. It can be positioned for viewing from either the
left hand or right hand side of the machine. The default position is for viewing
Length Adjustment Hand
Screw
Rear Hand Screw