Waters Network Systems GSM2109-1009-8PoE User’s Manual
Page 85
Command Level
Description
Example
bandwidth
type all
I
Set interface ingress limit
frame type to “accept all
frame”
switch(config)#interface
fastEthernet 2
switch(config-if)#bandwidth
type all
bandwidth
type
broadcast-mul
ticast-
flooded-unicas
t
I
Set interface ingress limit
frame type to “accept
broadcast, multicast, and
flooded unicast frame”
switch(config)#interface
fastEthernet 2
switch(config-if)#bandwidth
type
broadcast-multicast-flooded
-unicast
bandwidth
type
broadcast-mul
ticast
I
Set interface ingress limit
frame type to “accept
broadcast and multicast”
frame
switch(config)#interface
fastEthernet 2
switch(config-if)#bandwidth
type broadcast-multicast
bandwidth
type
broadcast-only
I
Set interface ingress limit
frame type to “only accept
broadcast frame”
switch(config)#interface
fastEthernet 2
switch(config-if)#bandwidth
type broadcast-only
bandwidth in
[value]
I
Set interface input bandwidth.
Rate range is from 100kbps to
102400kbps or to 256000
kbps for Giga ports. Zero
means no limit.
switch(config)#interface
fastEthernet 2
switch(config-if)#bandwidth
in 100
bandwidth out
I
Set interface output
bandwidth. Rate range is
from 100kbps to 102400kbps
or to 256000 kbps for Giga
ports. Zero means no limit.
switch(config)#interface
fastEthernet 2
switch(config-if)#bandwidth
out 100
show
bandwidth
I
Displays interfaces bandwidth
control
switch(config)#interface
fastEthernet 2
switch(config-if)#show
bandwidth
state
[enable |
disable]
I
Use the state interface
configuration command to
specify the state mode of
operation for Ethernet ports.
Use the disable form of this
command to disable the port.
switch(config)#interface
fastEthernet 2
h(config-if)#state Disable
show interface
configuration
I
Displays the status of the
interface configuration
switch(config)#interface
fastEthernet 2
switch(config-if)#show
