Waters Network Systems
User’s Manual
Page 15
GSM-2116 and GSM-2124
Once you have set the IP address of the switch, you must save the configuration. The CLI
command is:
save start
.
A detailed list of CLI commands can be found in Section 6.0.
4.3
Configuring the Switch via the Web
You can configure and monitor the switch through:
CLI
Web browser
SNMP manager. The user interface for SNMP is not covered at this time.
Before you are able to communicate with the switch, you must know the IP address of the
switch. Once you know the IP address, follow these instructions:
1. Connect the switch with a UTP cable to your workstations.
Note:
If the workstation connects to the switch, you will have to setup the same subnet
mask between them.
2. Access your web browser or use the console connection.
Note
: If you make changes to the configuration, you must
save
the configuration before
rebooting the switch.
Assign an IP address,
For example:
IP = 192.168.1.100
Subnet Mask = 255.255.255.0
Default Gateway = 192.168.1.254
Figure 4.2
Ethernet LAN