52
|
90
Safety Introduction Product Overview
Installing the OIT
1. Locate one end of the M12, 8-pin cable.
2. Align the pins and key in the plug to the connector.
3. Secure the plug into the connector.
Note:
Do not force the plug into the connector, you will damage it.
4. Ensure that there is a minimum of 5 inches (125 mm) behind the panel
opening to give the cable enough room to bend
).
Figure 39
5. Use the included hardware (digital OIT) or locally source the appropriate
hardware (manual OIT) to secure the OIT to the panel.
6. Route the cable to the control box.
7. Connect the cable to the control box. Refer
to:
"Connecting M12 Cables to the Control Box" on page 52
Connecting M12 Cables to the Control Box
1. Remove the cover. Refer to:
"Removing the Cover" on page 56
.
2. Align the pins and key in the plug to the connector.
Note:
Do not force the plug into the connector, you will damage it.
3. Secure the plug into the connector.
4. Connect the cable to the appropriate connector on the control box
(
).
Figure 40
