Assembly and Operating Instructions Sand Filter System without Pre-filter
English
15
Step 16:
The hose is attached to the suction side of the
pump, which runs to the swimming pool skimmer.
Step 17:
The return hose to the inlet nozzle is connected to
the ‚Return‘ hose connection via the valve.
Step 18:
On the right-hand side of the valve, you can find the
hose connection for backwashing (dirty water into
the drains). This is labeled ‚Waste‘.
2.3 FILLING WATER IN - COMMISSIONING THE FILTER
2.3.1 INSTALLATION WITH BUILT-IN SKIMMER
After the swimming pool has been filled with
water up to at least the middle of the surface
skimmer, the water automatically runs into
the pump. If necessary, we recommend the
installation of a gate valve in addition. It can
be used to interrupt the water flow of the filter
system.
2.3.2 SYSTEM WITH SUSPENSION SKIMMER
Before the suction hose is connected to the
skimmer, it must first be completely filled with
water.
2.3.3 FRAME POOL OR QUICK UP POOL
Please connect the suction hose and also the
return hose to the two hose fittings of the pool.
We recommend to install a suitable skimmer
offered by the pool manufacturer in addition.
This is usually connected with a separate
hose from the inside of the pool.
In no case should the 2 hoses simply hang
into the water and the filter system be installed
without a skimmer. This can and will not work
and there is a risk of irreparable damage to the
filter system/pump.
