Assembly and Operating Instructions Sand Filter System without Pre-filter
12
English
2. INSTALLATION OF SAND FILTER SYSTEM
Step 1:
The following tools are required for this: Phillips
screwdriver, Teflon tape, 7 mm wrench, possibly
drill, possibly cordless screwdriver, rubber hammer.
Step 2:
Insert the drain valve into the pre-drilled hole on the
filter tank, i.e. from the inside to the outside. While
doing so, please mount a rubber seal each from the
inside and from the outside and then fix the drain
valve with the lock nut from the outside.
Step 3:
(Instructions for model with riser pipe 1)
At first, screw only 2 of the filter cartridges into the
riser pipe.
Step 4:
(Instructions for model with riser pipe 1)
The other filter cartridges are inserted in the tank,
as otherwise the assembled riser pipe would not fit
through the tank opening.
Step 5:
(Instructions for model with riser pipe 2)
If you use our alternative tank with fixed (glued) filter
basket, it is simply inserted into the filter tank.
