WATERKOTTE EcoTouch Ai1 Geo, Planning And Installation

Page: 46 / 60

Commissioning
12.11.2015
46 / 60
Z21826
Copyright

2013 by: WATERKOTTE GmbH. Subject to changes
Info: During initial start-up, the specified limits are often exceeded, thus numerous
warning messages could appear.
For this reason, the warning messages occurring during this period can be disa-
bled by service personnel, see
Operating manual for heat pump controller .
After completing installation and wiring and tubing of indoor and outdoor units,
check for refrigerant leaks, loose power supply or control wiring, wrong polarity,
and ensure that no single phase in the power supply is disconnected.
Compressor will not operate unless the power supply phase connection is correct.
12.3 Control of the entire operation
This heat pump is equipped with an efficient electronic control system. All neces-
sary settings and options are described in the operating manual of the controller.
Tip: The correct use of the controller saves money. Particularly the correct settings
of flow temperature, hot water temperature, heating curve and heating times can
result in substantial cost savings.
12.4 Turning off the heat pump
Procedure:

Switch OFF the main switch at the heat pump.

Turn OFF the circuit breakers: Compressor, control voltage and electrical
heating element.
12.5 Turning off the heat pump for a longer time
- see 12.4 -