WATERKOTTE EcoTouch Ai1 Geo, Planning And Installation

Page: 13 / 60

Components and installation
12.11.2015
13 / 60
Z21826
Copyright

2013 by: WATERKOTTE GmbH. Subject to changes
4 Components and installation
4.1 Heating system Basic Line Ai1 Geo
All components of the heating system are mounted in a protective steel plate
housing which is intended for installation inside. The base frame consists of a
bent, thick-walled sheet steel. Together with the rear panel frame, which also con-
sists of a thick-walled sheet steel, it forms a unit. Side panels, cover, front and the
tilt-mounted, ergonomic control panel can be removed.
All housing parts are optionally available in high-gloss white or stainless steel fin-
ish. Sound insulation ensures low noise emissions.
4.2 Structure
Complete hot water heating system with integrated central hot water supply run,
consisting of: heat generator (heat pump), heat-source technology, electrical re-
sistance heating for start-up and stand-by, control and electrical control, storage
stainless steel integral foam insulation), full-constant Electrical and Control En-
gineering, touch display with BASICPRO software, Smartphone Control with
BASICPRO Mobile Software, diagnostic system.
All hydraulic connections positioned on the back. All units within the scope Vice-
mounted with removable , all-round heat and sound insulated lining , colour sig-
nal white (RAL 9003 ).
4.2.1 Heat pump module
The heat pump unit includes the whole hydraulic technology. The built-in con-
sole consists of compressor and heat exchanger .
4.2.2 Compressor
The compressor features a fully hermetic design in approved leading scroll tech-
nology (fig. left). Evaporator and condenser are designed as soldered stainless
steel plate packs with reverse flow circuits, according to state-of-the-art develop-
ment, tailored to the new non-flammable safety refrigerants that will be required by
law in the future. In combination with ester oil (biodegradable), this guarantees op-
timum lubrication conditions, low friction losses and therefore the highest possible
life expectancy for the compressor according to the latest industrial research find-
ings.
The cooling circuit is designed in accordance with the relevant safety regulations.
Manufacturing quality is carried out based on ISO 9001ff, supplemented by an au-
tomated computer-monitored quality test (pressure stress and helium leak test) in
addition to inspection of all parameters in a subsequent trial run.