26
THERMOSTAT OPERATION
TP32W02 Thermostat
Programming Items
2
1
8
9
4
3
10
12
6
11
5
7
13
14
1
2
3
4
5
6
7
8
9
10
12
13
14
11
Displays and “
Keypad Lockout
” when in keypad
lockout mode.
Displays and “
Temperature Limit
” and “
Keypad
Lockout
” when limited range is activated and locked.
Displays only “
Temperatrure Limit
” when limited range
is activated.
Indicates period of day being programmed.
RUN SCHEDULE (run program) button.
SET TIME button or HOLD temperature button.
Displays “
Change Filter
” when the system has run
for the programmed filter time period as a reminder
to change for clean your filter. Displays “
Humidifier
Pad
” when the system has run for the programmed
filter time period as a reminder to change or clean your
humidifier pad.
COPY button or INSTALLER CONFIG button.
CLEAN DISPLAY button allows 30 seconds to wipe off the display or ADVANCE DAY button for programming.
Used in programming to set time and in configuration menu to change selections.
"
Hold Until
" indicates the time when a temporary hold period will end.
"
Hours
" and "
Days
" displays during steps in installer configuration.
The words "
Hold At
" are displayed when the thermostat is in the
HOLD
mode. "
Temporary Hold At
" is displayed when the
thermostat is in a temporary
HOLD
mode.
"
Call For Service
" indicates a fault in the heating/cooling system. It does not indicate a fault in the thermostat.
"
Stage 1
" indicates when heating or cooling stage is energized. "
+2
" also indicates when a second stage is energized.
"
Copy
" indicates the copy program feature is being used during programming.
System
button for selecting
Heat/Off/Cool or Auto(Heat/Cool)
Fan
(Auto/On)
Stage 1
Indicates when thermostat is
calling for Heat or Cool
Time
and
Day
Room Temperature
and
Setting Temperature
(flashes when compressor is in 5 minute lockout)
Temperature Up/Down
Displays indicating the current power
level of the 2 “AA” batteries. When the batteries
become low, “Change” will appear with the .
The batteries should be replaced at this time.
Menu
for Cleaning, Programming
and Setting Time
Home Screen Description
OPERATING YOUR THERMOSTAT
Choose the Fan Setting (Auto or On)
Set the FAN Switch to
Auto
or
On
.
Fan
Auto
is the most commonly selected setting and runs the fan only when the heating or cooling system is on.
Fan
On
runs the fan continuously for increased air circulation or to allow additional air cleaning.