Refer Joey re chart image
6.8 Motor Pause
The Waterco ECO-V 150
user interface has a “motor pause” feature that will allow
the user to temporarily stop the Waterco ECO-V 150 for maintenance work without
disrupting the 24 hour schedule (i.e., for backwashing the filter). If the Waterco ECO-
V 150 is currently running, the user can press and hold the START button for more
than three (3) seconds and the Waterco ECO-V 150 will stop and remain off until the
user presses and holds the START button again for more than three (3) seconds.
The START and OVERRIDE buttons will blink once every second indicating that the
“motor pause” feature is enabled. These LEDs will stop blinking once this feature is
cancelled.
6.9 Temporary Stop with Digital / Serial Input
Caution:
Temporary stop functionality only works while the Waterco ECO-V 150 is
being controlled by a digital or serial input. If the motor is being controlled by the
integrated key pad and STOP is pressed, the motor will stop and remain stopped.
The Waterco ECO-V 150
has a “temporary stop” feature that will immediately stop
the Waterco ECO-V 150 when being controlled by a serial or digital input. The user
can press the STOP button while the Waterco ECO-V 150 is running and the
Waterco ECO-V 150 will stop and stay off for four (4) minutes.
Once this time has elapsed, the Waterco ECO-V 150 will return to normal operation
and accept an input from digital or serial input source. Refer to section 9 for
additional details on digital inputs.
Note:
If the Waterco ECO-V 150
is operating from serial or digital input, the ‘0 RPM’
LE
D of the bar graph will blink once every second indicating the “temporary stop”
Summary of Contents for Hydrostorm ECO-V 150
Page 29: ......