I pg 05
Waterco Hydrochlor ST
Manual Override switch (see fig. 2)
ON Position:
the timer is permanently ON irrespective of tappet positions. This is the recommended
setting to work in combination with Waterco’s Aquamaster or ChemfloPlus.
AUTO Position:
the timer is operating on timed control as determined by tappet positions. This the
automatic operation position.
OFF Position:
the timer is permanently OFF irrespective of tappet positions.
CHLORINE PRODUCTION LEVELS
The output of the chlorinator can be adjusted to reflect the different seasonal
requirements in order to maintain satisfactory chlorine sanitizer levels.
The amount of chlorine produced can be adjusted by pressing the
CHLORINE
PRODUCTION
key. Press button to raise production. If production already set at
maximum it will turn to zero and each press will raise production by one LED till MAX.
If the pool water is over chlorinated, simply reduce the chlorine production set level.
Pump Only Mode:
The Chlorinator can be set to activate the pump only for maintenance
purposes (e.g. backwashing the filter). The pump only mode will disable the flow
detection and chlorine production in the cell. To set press CHLORINE PRODUCTION
key until Pump Only mode LED is lit.
“ON” Position
“AUTO” Position
“OFF” Position
Figure 2