10
OPERATING DISPLAYS AND MAINTENANCE
1.
GENERAL OPERATION:
When the system is operating, one of four displays may be shown and will alternate with the installing
dealer’s name and phone number for future service. Pressing
NEXT
will alternate between the displays.
1.
CURRENT TIME OF DAY
and
GPM
2.
FLOW RATE
which is the current treated water flow rate through the system in Gallons Per Minute
3. CAPACITY REMAINING
which is the gallons that will be treated before the system signals a regeneration cycle
4.
DAYS TO A REGEN
is the number of days left before the system goes through a regeneration cycle, based on the days
override value
5.
DEALER NAME AND PHONE NUMBER
will only appear if set by the dealer. This scrolling display offers dealer
contact information for instances when service is needed.
If the system has called for a regeneration that will occur at the preset time of regeneration, the words “REGEN TODAY” will
appear on the display.
If a water meter is installed, “GPM” flashes on the display when water is being treated, indicating gallons per minute going
through the system.
2.
REGENERATION MODE:
Typically a system is set to regenerate at a time of
no water usage. If there is a demand for water when the system is regenerating,
untreated water will be delivered. When the system begins to regenerate, the
display will include information about the step of the regeneration process and the
time remaining for that step to be completed. The system runs through the steps
automatically and will reset itself to provide treated water when the regeneration
has been completed.
3.
MANUAL REGENERATION:
Sometimes there is a need to regenerate before
the control valve calls for it. This may be needed if a period of heavy water use is
anticipated or when the system has been operated without salt.
• To initiate a manual regeneration
at the next preset regeneration time,
press
and release
REGEN
. The words “REGEN TODAY” will flash on the display
to indicate that the system will regenerate at the next regeneration time (set
in Programming, steps 4 and 5).
If you pressed the
REGEN
button in error,
pressing the button again will cancel the command.
• To initiate a manual regeneration
immediately,
press and hold the
REGEN
button for three seconds. The system will begin to regenerate immediately.
This command cannot be cancelled.
Once a manual regeneration is initiated, the unit will go into the FILL position. This position allows water to enter the brine
tank until it reaches the proper level. Once this position is complete, you will notice a 240 Minute (4 hours) SOFTENING
position. This 4-hour window allows the salt to dissolve and achieve proper brine strength. During these FILL and
SOFTENING positions, you will have softened water available for use. Once the unit advances to the BACKWASH position
and subsequent positions thereafter (see Start Up Instructions for regeneration sequence), the water softener will deliver water,
but it will be untreated.
IMPORTANT:
With the Dry Salt Storage Feature, the brine tank will refill 4 hours before the actual regeneration occurs.
You may experience a small amount of noise for a short period of time at 10:00 p.m. (with typical setting) on the night that
regeneration is to occur. This noise is only the brine tank filling and at no time during this process will you be without treated
water.
The user can scroll between the displays as desired.
1
FLOW RATE
GPM
8.0
CAPACITY REMAINING
2
5
TIME OF DAY
MON
PM
GPM
2:40
8
GAL
GPM
1600
8
GPM
3
8
3
DAYS TO A REGEN
4
555 5555555
DEALER NA
BACKWASH
8:22
REGENERATION MODE
MANUAL REGENERATION
REGEN TODAY
MON
GPM
2:40
8
PM
REGEN TODAY
and
TIME OF DAY
will flash alternately if a regeneration
is expected tonight.
